|
Ground wire on 3GX and more
2 Attachment(s)
Hi
I'm wiring a trex nitro with a 3gx system. I have my power and ground on two separate contacts, and rather than rewiring them I was wondering if the below setup would work? Attachment 2245869 Also, I guess the power should go directly to the battery pack right? I'm using the following battery: Attachment 2245870 Previously, the system was setup with a VBAR and calibrated perfectly. With this new 3gx, do I need to redo the mechanical calibration, or can I setup it all from the controller? The 3gx is already paired with my DX8 from previously as well. Finally, any knowledge about the 3gx version 5? Should I upgrade from my version 3? Kind Regards, Peter |
2 Attachment(s)
I relooked at the manual, and found that I made a mistake (page 6): Sorry was not allowed to post the link...
Here is the correct image: (or see attachment) I have sent an email to Align, but any answer from you guys would be much appreciated. Kind Regards, Peter PS: I also found out that I shouldn't run my servoes from the 7.4 battery as it will fry them... ooooppps.... I now purchased a 6.0v battery 2500 mah |
| All times are GMT -8. The time now is 09:56 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.