RCU Forums

RCU Forums (http://www.rcuniverse.com/forum/)
-   RC Helicopter General Discussions (http://www.rcuniverse.com/forum/rc-helicopter-general-discussions-129/)
-   -   S9551 servo question in turbine heli (http://www.rcuniverse.com/forum/rc-helicopter-general-discussions-129/11645286-s9551-servo-question-turbine-heli.html)

Springbok Flyer 03-08-2018 12:54 AM

S9551 servo question in turbine heli
 
Hi guys,

I have been using these servos in my AirStar Hughes 500E Turbine heli since 2008. However I find that they need replacement quite often. When the first one just stopped working I ordered 4 from Tower Hobbies and replaced the culprit. But today I used up the last two I still had in stock. The power is 5.5volt so I am not putting more than 6 volt through them. Perhaps it is a heat problem. It seem to be the fore and aft (elevator) servos that die every time.

Your suggestions will be welcome. It will also be great if any alternative low profile servos can be suggested.

Regards,

JanR


All times are GMT -8. The time now is 12:56 AM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.