Shark 450 issues for newbie
#1
Junior Member
Thread Starter
Join Date: Aug 2010
Location: Bordentown, NJ
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Shark 450 issues for newbie
Guys - big time newbie here, I want to learn how to fly my Heli but when turning on the transmitter first then I plug in the battery - beeps several times and red led's remain lit on the gyro and the mini receiver. I've turned throttle all the way down - nothing, cannot contol any of the servo's?? The operating manual is not the most helpful document i've ever used. Ideas from the heli pro's as to what I'm doing wrong? Thanks in advance..
#2
Member
Join Date: Nov 2011
Location: San Juan, PUERTO RICO (USA)
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
RE: Shark 450 issues for newbie
Was it RTF (ready to fly) or ARF (almost ready to fly).
It could be any ofseveral issues or a combination of them.
Either way I would check how the servos are connceted to the RX. Polarity wise, orange wires facing the same direction.
How are your servo travel settingson the TX (they should be 100%)
How are your curves, maybe they are flat.
It is unlikely for ALL theservos be deffective.
Maybe the RX is DOA or the TX, but usually the RX are the ones that die.
Hope this helps
It could be any ofseveral issues or a combination of them.
Either way I would check how the servos are connceted to the RX. Polarity wise, orange wires facing the same direction.
How are your servo travel settingson the TX (they should be 100%)
How are your curves, maybe they are flat.
It is unlikely for ALL theservos be deffective.
Maybe the RX is DOA or the TX, but usually the RX are the ones that die.
Hope this helps