Do you guys think this setup will work? Edf jet rail car.
#1
Junior Member
Thread Starter
Join Date: Dec 2012
Location: Hot springs , AR
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Do you guys think this setup will work? Edf jet rail car.
My motor specs are-
- [*]4500 KV BrushlessDuct Fan motor for 64 mm Duct Fan[*]Weight: 50 gram (Motor)[*]64mm Duct Fan unit[*]Weight : 25g Fan[*]the max thrust :750g[*]max current : 28A. The ESC that I have specs are-
- Constant Current: 20A
- Max Current: 30A
- Sustaining Voltage: (Li-ion/Li-poly: 2-3v) / (NiMh/Nicd: 6-12v)
- Low-Voltage Cutoff: Auto detect and set
- Size: 42mm x24.5mm x 5mm
- Weight: 22g[*]Build up in BEC :2A/5V[/list]
And the battery specs are-Capacity: 1500mAhVoltage: 11.1VConnector Type: EC3Wire Gauge: 14 AWGCharging Connector: JST-XHWeight: 3.86 oz (110g)Configuration: 3SLength: 2.85 in (72.50mm)Width: 1.40 in (35.60mm)Height: 0.85 in (21.60mm)Maximum Continuous Discharge : 20CBurst Rate: 30C
Specifications:
Type:LiPo
Capacity:1500mAh
Voltage:11.1V
Connector Type:EC3
Wire Gauge:14 AWG
Charging Connector: JST-XH
Weight:3.86 oz (110g)
Configuration:3S
Length:2.85 in (72.50mm)
Width:1.40 in (35.60mm)
Height:0.85 in (21.60mm)
Maximum Continuous Discharge :20C
Burst Rate: 30C
Vehicle models vary! ..We DO NOT guarantee this will fit the vehicle specified in this listing!!
#2
Junior Member
Thread Starter
Join Date: Dec 2012
Location: Hot springs , AR
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
RE: Do you guys think this setup will work? Edf jet rail car.
Excuse the double batty listing and the last little part there. It was copy and pasted.