EXM MINI
#261
Senior Member
Thread Starter
Join Date: Mar 2008
Location: Trofa, PORTUGAL
Posts: 468
Likes: 0
Received 0 Likes
on
0 Posts
Hi . Please send email to : [email protected]
New container arrive next week :-)
Thanks
Joao Matos
www.joaomatosrc.com
New container arrive next week :-)
Thanks
Joao Matos
www.joaomatosrc.com
#264
Senior Member
Thread Starter
Join Date: Mar 2008
Location: Trofa, PORTUGAL
Posts: 468
Likes: 0
Received 0 Likes
on
0 Posts
#269
Hi, at the moment I made few flight and I not have the flaps fine adjust, the throws are 2cm in all surfaces, but it's only for test. When I have good information over this I will tell you.
Regards.
Carlos.
__________________________
www.cmjets.blogspot.com
Regards.
Carlos.
__________________________
www.cmjets.blogspot.com
#270
Join Date: Apr 2009
Location: Oostrozebekew-vl, BELGIUM
Posts: 83
Likes: 0
Received 1 Like
on
1 Post
Nevermind, maidened today and made a out landing. Not very hard, but al 3 the gearmountingplates broke out and crushed everything in the bottom of the nose. I have had harder landings with my dragon, ultra jet and kangaroo without any damage. For something that mentions in the manual is made for everyday use, this is the most fragile jet I have ever seen.
#275
Junior Member
Join Date: Mar 2014
Location: Germany, Berlin
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Hello,
my throws are: elevator 10mm up & down, aileron 15mm up & 10mm down, rudder max throws, flaps 20mm for start and 50 mm for landing with 2mm elevator down mixing.
Regards
UK
my throws are: elevator 10mm up & down, aileron 15mm up & 10mm down, rudder max throws, flaps 20mm for start and 50 mm for landing with 2mm elevator down mixing.
Regards
UK