Sebart Mini Avanti w/ K45 build thread
#481
Join Date: Mar 2012
Location: Saugus, CA
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
Mini Avanti with K45
Where should the CG be for the mini avanti with a kingtech 45? Should the CG be performed with full fuel? I installed the engine as far forward on the rails that I could and using a CM jets 1.3L tank.
#485
My Feedback: (30)
Test Flew mine yesterday in a 30 km/h wind straight down the runway, two flights so far. Powered by K-45G2, balanced at 145mm, the aircraft tracked well despite windy conditions. Most flight at 1/2 throttle, full throttle only on take off. Its great aircraft and is plenty fast at 1/2 throttle for my style of flying!
#493
My Feedback: (11)
He posted on Facebook that he's out of material for pipes and it's going to be a while.
To all my hobby customers and friends. Last few months I been out of metals to making pipe. Even till now I won't expect to get my metals order sometime in mid September. Also big spike on cost too.
RC Jets business is been very tough for me in the last few years. Cost of materials and machine shop is too high. Most of my
products now is very little profit left to continue of making.
The pipes I still continue doing business when I get my metals. Some of the pipe
use more material there will be price increases.
Since last few months I had no income from pipes business. I was desperate seeking for work.
I did found a job and been busy working use my special skills I have over 30 years.
Now I'm officially a handyman. Anything I can fix. For the hours I work is 2-3 time more income than hobby business.
Therefore I no longer be able to put my 100% energy to hobby business. I only can do part time. Please understand for any delaying.
Thanks all for the business support
RC Jets business is been very tough for me in the last few years. Cost of materials and machine shop is too high. Most of my
products now is very little profit left to continue of making.
The pipes I still continue doing business when I get my metals. Some of the pipe
use more material there will be price increases.
Since last few months I had no income from pipes business. I was desperate seeking for work.
I did found a job and been busy working use my special skills I have over 30 years.
Now I'm officially a handyman. Anything I can fix. For the hours I work is 2-3 time more income than hobby business.
Therefore I no longer be able to put my 100% energy to hobby business. I only can do part time. Please understand for any delaying.
Thanks all for the business support
#494