CARS II

My Feedback: (7)

Belongs to a friend of mine, I will most likely be doing the maiden flight, he got a K160 for it, looking at the numbers on the pic, which engine is best suited for it?

Thanks

sysiek

My Feedback: (176)

Make sure to check the elevator mechanism and the connection between the elevator’s, they have problems with that area with breaking or other failures

CARS II

My Feedback: (7)

Hey!

Thanks for the advice, this Hawk is post problems, I know the story of the problems they created by using honeycomb on the elevators.

His one comes with the improved H stab and the new elevator/servo mechanism.

CARS II

My Feedback: (7)

sysiek

My Feedback: (176)

I think this was about using the carbonfiber instead of the aluminum jointer, when drilled the carbonfiber usually breaks right through the drilled area

p-40lover

l had a 160 in mine lots of power.. just watch your speed with the flaps it will plank out the elevator as a friend of mine found out that l sold the plane too on maiden flight for him they didn't remember about the issue to it was to late an down it went..

CARS II

My Feedback: (7)

Are you telling me the 160 was enough for this beast? The recommended engines are from 170 to 200, did you have any reserve trust? Or were you flying at 90% stick?

emart

Here is a link to my Buddies maiden 9 years ago with a kingtech K-180