Kingtech presents the all new T1 sports jet
#227
Hi Everyone,
Here's something you might also want to do in case if your servo bracket is somewhat loose. The little black dot right by the strut is a set screw, drilled and tapped to pin down the steering servo bracket.
Cheers,
Barry
Here's something you might also want to do in case if your servo bracket is somewhat loose. The little black dot right by the strut is a set screw, drilled and tapped to pin down the steering servo bracket.
Cheers,
Barry
#241
Hi guys, I decided to add an extra anti rotational pin at the trailing edge of the vertical fin. The prototype Kris and I had out at Kentucky had a breach of integrity at the vertical fin spar clamp bulkhead, this was from the power of a K-170 pushing through a violent snap roll, since then the factory increased the thickness of the bulkhead and improved hysol mixing ratio, plus a bead of carbon fiber in place.
Regards,
Barry
Regards,
Barry
#242
#244
Hi guys, I decided to add an extra anti rotational pin at the trailing edge of the vertical fin. The prototype Kris and I had out at Kentucky had a breach of integrity at the vertical fin spar clamp bulkhead, this was from the power of a K-170 pushing through a violent snap roll, since then the factory increased the thickness of the bulkhead and improved hysol mixing ratio, plus a bead of carbon fiber in place.
Regards,
Barry
Regards,
Barry
Regards,
Barry
#245
Regards,
Barry
#246
Ronnie Derhacopian did an excellent job on these doors...
An aluminum L bracket, using the clamp that it comes with, and with a bit of shimming, fits perfect!
Regards,
Barry
An aluminum L bracket, using the clamp that it comes with, and with a bit of shimming, fits perfect!
Regards,
Barry