rudder,better way for securing the rudder with elevators section.

So I’m installing the blind nut right in the wood,the will be easy and strong way tho hold the section.

This is the finished rudder securing,my way,maybe someone could use this idea.

So after some arctic super cold 🥶 ,back to the tail section,the wooden doles are to have same distance for the carbon fiber rods when glued to elevators they must be done like this both elevators on the same time with the rods press on the same time don’t glue the rods separate to elevators one the side they will not fit correctly .

The pictures don’t upload in order please just find a way to puzzle them right

This is not the first one I’m assembling so I’m showing all the improvements to make the assembling easier and more friendly for future use,there lots more stuff to share so just watch the progress and thanks for following.

So the tail section is ready with all pins glued and straight.

So today I was working on the wings plumbing and servo cables,to do this job right and easy you need a strong earth magnet 🧲 and mechanic lost washers type magnet 🧲 this will help and it’s the only easy way to do this job right and not go super nuts trying out,please look at the pictures and try to puzzle them out they don’t upload in order just one of the rcuniverse upgrade😁.

Just got the turbine for this jet k-180 this should work just fine. And a picture from Route 66 jest 2019

Ok back to the Diamond building,so I just glued the 3D printed uat holder and piece of plywood to screw up the smoke pump this one should be something crazy it’s brushless!

Ebay special [img]blob:http://www.rcuniverse.com/af43e694-d228-4dac-973c-7a2cf781d096[/img]

So not much today just fished some power cables for the rx and turbine ecu ,the 12 gauge for the ecu and 14 gauge for the rx ,they need to be made the ones I have from aviation design are way to short 💩 so not so happy about spending the money on something that doesn’t work.

today just batteries and plugs , the plugs so I could remove the batteries whatever I need like a winter storage or to charge them for new ones.

So the jet is finished and will wait for the maiden flight probably until spring, so the best part is that I achieved the perfect CG with no extra weights in front just batteries.