BobCat Antenna HELP
05-25-2003, 12:00 AM
#1
Thread Starter
My Feedback: (4)
Join Date: Mar 2002
Location: Scottsdale,
AZ
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
BobCat Antenna HELP
Hi Guys
Just how did you manange to get the antenna wire inserted through the interior bulkhead and all the way into the nyrod ?
Thanks!
Just how did you manange to get the antenna wire inserted through the interior bulkhead and all the way into the nyrod ?
Thanks!
05-25-2003, 12:23 AM
#2
My Feedback: (15)
Join Date: Feb 2002
Location: Marine on St. Croix,
MN
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
ff
Line up with blue nyrod and drill a hole through the bulkhead. Insert the nyrod. Spray a little Pledge on the antenna and feed it through. Piece of cake!
Good Luck
Scott
Good Luck
Scott
05-25-2003, 04:47 PM
#4
Senior Member
My Feedback: (1)
Join Date: Dec 2001
Location: Oxford, MS
Posts: 3,241
Likes: 0
Received 0 Likes
on
0 Posts
BobCat Antenna HELP
Or buy a piece of the clear dubro antenae rod material and use that instead of the yellow nyrod stuff. Much easier to shove the antenae wire into.
05-25-2003, 07:40 PM
#5
Thread Starter
My Feedback: (4)
Join Date: Mar 2002
Location: Scottsdale,
AZ
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
BobCat Antenna HELP
Thanks guys for the suggestions. I wound up usings a "pull cord" of solid 18 awg wire to pull the antenna wire through. Tried the WD40 and the Pledge and didn't have the nylon tube available. I think the 90 degree heat here made the antenna lead too flexible to push through. Appreciate all the suggestions.
BRG
Cooper
BRG
Cooper
