Jetronics Brake Valve Setup
Hello Guys,
I am helping my friend set up the Jetronics brake valve: http://www.jet-tronics.de/Jet-Tronic...ve%20de-en.pdf And I have a problem setting it up. I would like to use it on a simple switch as on/off brake only, but I did try a slider also (according to the instructions) on his Futaba 18SZ. Even if I do the setup exactly like in the manual, learn both limit points, at this point, even before the 3 second red led press, the wheels are locked and braked. And if I hold the red button 3 seconds, I don’t see anything happening. the wheels are fully braked in both points, and when I flick the switch on Tx the red/green light light up accordingly for 1 second, then come off. But in both conditions, wheels are always braked! How can I set it up to completely release brake on one side of the switch? Is there an instructional video maybe? I figured some pilots here might be using these. thanks. |
Make sure your airlines aren't switched up. Had the same problem a couple weeks ago - I had the airlines swapped.
|
lines are not reversed
|
I can't get your link to open, but if your valve is like this:
http://www.altecare.com/jettronicsbrake.pdf It worked flawlessly for me. I recently had to convert back to an on board air brake system for brakes, so I recently had to set it up. Good Luck! |
2 Attachment(s)
Originally Posted by i3dm
(Post 12327536)
Hello Guys,
I am helping my friend set up the Jetronics brake valve: Attachment 2227688 And I have a problem setting it up. I would like to use it on a simple switch as on/off brake only, but I did try a slider also (according to the instructions) on his Futaba 18SZ. Even if I do the setup exactly like in the manual, learn both limit points, at this point, even before the 3 second red led press, the wheels are locked and braked. And if I hold the red button 3 seconds, I don’t see anything happening. the wheels are fully braked in both points, and when I flick the switch on Tx the red/green light light up accordingly for 1 second, then come off. But in both conditions, wheels are always braked! How can I set it up to completely release brake on one side of the switch? Is there an instructional video maybe? I figured some pilots here might be using these. thanks. I am having this exact problem with the JT brake valve tonight. Did you figure it out? Thanks Gary |
Yes, he had the input and output lines connected together by mistake.
the valve was fine. |
Will recheck my lines tomorrow. Still no good today.
Thanks |
i am still having problem with this valve
|
All times are GMT -8. The time now is 05:16 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.