Servo troubles
#1
Junior Member
Thread Starter
Join Date: Mar 2011
Location: , UNITED KINGDOM
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Servo troubles
Hi
I have the ACME conquistador.
One last question Have just re connected up the throttle to the servo link. When testing it with out running the engine the carb opening is wide open.
I changed the throttle trim on the remote control but that hasn't helped. I did notice that their is two holes I could connect the servo link to.
I have tried both holes but both had the same result. Any ideas?
Cheers
Tom
I have the ACME conquistador.
One last question Have just re connected up the throttle to the servo link. When testing it with out running the engine the carb opening is wide open.
I changed the throttle trim on the remote control but that hasn't helped. I did notice that their is two holes I could connect the servo link to.
I have tried both holes but both had the same result. Any ideas?
Cheers
Tom
#2
Senior Member
Join Date: Oct 2010
Location: mackay, AUSTRALIA
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo troubles
At a guess it sounds like the throdle reverse switch has been activated.Usually found on the transmitter.
Or try centering the servo while its on, adjust all trims settings to centre, take the servo arm of the servo, while its all switched on still, make sure everything is centered, carefully put servo arm back on in centre position, carby should now be closed to idle.
Or try centering the servo while its on, adjust all trims settings to centre, take the servo arm of the servo, while its all switched on still, make sure everything is centered, carefully put servo arm back on in centre position, carby should now be closed to idle.