kyosho usa 1 nitro crusher ( kyosho usa-1 nitro crusher twin \ DF)
#54
Member
Thread Starter
Join Date: Feb 2011
Location: Nunica,
MI
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Yeah buddy , just dont get the time like i used to. Back then i was on 2nd shift... Now im on first.. But im slowly finishing that one which was my first idea, wanna get her done, wanted to see if that pilot shaft engine type would work, but i shimmed it out all the way and thats where it sits off center so i gotta take that one off. And i got a few other projects i need to finish
#61
Wheels/Tires
Anyone have a trick they use to remove tires from a wheel? I tried to clean one of these 'chrome' rims & wound up wiping the finish right off. I'd like to pry the rim off of the tire completely so I can completely strip the chrome plating & either dye or paint it, but if I use a screwdriver or am not completely careful, I can very easily chip/damage the rim. I know some folks have managed to paint rims like this while mounted on the tire, but that's something I know I'll mess up. Any suggestions?