Blue thunder in my CEN NT-16
#1
Senior Member
Thread Starter
Join Date: Nov 2003
Location: st. louis,
MO
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
Blue thunder in my CEN NT-16
I just took apart my engine in my MT2 to rebuild it...inside the engine there was blue gunk all over...I used to run Blue thunder 20% sport. not anymore. BTW I still gotta order a piston and sleeve for my engine but does the shaving of the ports have a noticeable increase in power? I noticed that there's not a whole lot to shave on the CEN sleeves but it could use a little bit. and for any of you CEN guys, is there anything I can do to this engine to give it more power? eventually I would like to drop in a .18 but I'm not ready to do that yet.
#2
Senior Member
Join Date: Oct 2003
Location: Plymouth,
MA
Posts: 829
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blue thunder in my CEN NT-16
you can try porting the exhaust manifold. if you look, the size of the manifold opening is much smaller than that of the exhaust outlet on the crank case. it wouldnt hurt to widen the intake on the manifold to reduce the airflow restriction.
#4
Senior Member
Thread Starter
Join Date: Nov 2003
Location: st. louis,
MO
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blue thunder in my CEN NT-16
I'm gonna start using Trinity monster horsepower...a lot of people have told me that I'm gonna like it a lot. Already started running it in my sportmaxx.