STREETKING

My truck was just starting, but when I gave it throttle, it kept cutting off. So, some other peo-le gave me some advice and I did this, and it ran ok for a little while. Now, I went to try to tstart it again to run it, and it just simply won't start! I don't know why. Do your mixture setings have htat much to do with the engine starting?? And I checked the glow plug and it lit up, but I don't think that it lit to the very end of the coil. The part of the coul that sticks out of the plug wasn't lit. Is this a damaged plug?? Any advice on what to do would be greatly appreciated.

jefx

If you suspect that your plug is bad, then replace it. Compare it to a new plug to see if it's bad. And yes, needle settings DO have that much to do with it. Put it back to the stock settings and go from there. Also, if you're having this much trouble, then maybe you should try a different brand or type of plug. What kind of truck is it even?

ThermalRD

What truck are we talking about?
What motor are we talking about?
Describe how it was running when all this happened?
What fuel are you using?
What plug is in the motor?

Need more info please.

Thanks, Matt

FoxRacing500r-delete

Dude try what I do.When you turn it over blip the throttlerepeatedly.

STREETKING

my bad folks. the truck is an Ofna Mp Sport. the engine is a hyper 21. i took it to my LHS and the owner hooked me right up!! he's been in the sport for years, and he tuned it and got it to the right temp. my idle screw wasn't set right, but it's perfect now. it runs, it idles and it starts right up. thanks for all of your help people. i'm a newbie and i'll have more questions so look out for me yall!!