zjwhitrock

does any one besides traxxas make water proof servos??

Evader ---> MGT

You can water proof any servo within minutes using a balloon, plasti-dip, grease, or a few rubberbands...

But I don't think so...[]

ericem

To seal it realistically all you have to do is grease the servo horn. Everything else should be sealed pretty tight. I remember I dipped a s3003 servo in a bottle of water without grease or anything. Left it in there for a week. While it was still in the water I plugged it into a receiver and it worked perfectly.

robwiljas

I don't remember off the top of my head what models but Hitec makes some. Tower has them.

zjwhitrock

i found a few servos but this speed reading cant be right??

http://www3.towerhobbies.com/cgi-bin...?&I=LXGZU3&P=0

snowbl!nd

It's a sail winch servo - so those specs are most likely correct.

robwiljas

[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXUZ76&P=]Hitec HS-5625MG[/link]

[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXUZ80&P=]Hitec HS-5645MG[/link]

[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXMYH5&P=]Hitec HS-5965MG[/link]

[link=http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXMYH7&P=]Hitec HS-5985MG[/link]

There might be more, these are just the one's I found real quick.

zjwhitrock

ty but i was looking to get 2 servos for $60-80(no money left)

dakota_davies

heres a link on how to waterproof your existing ones. [link=http://www.societyofrobots.com/actuators_waterproof_servo.shtml]waterproof servos[/link]

zjwhitrock

ok ty

but when the servo gets wet it
A.doesnt center
B. when its not that wet it acts lik it has 2 diffrent center points(it goes back and forth)
any one know if the servo is ruind??

tmaxx_man87

i used silicone and a tmaxx shock seal around the horn to seal mine