TT EK4 needle settings
#1
Member
Thread Starter
Join Date: Feb 2003
Location: Perth, Western Australia, Australia
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
TT EK4 needle settings
I've lost my notes for the base settings for the EK4 needles, was wondering if anyone out there knows what it is...
#2
Member
Join Date: May 2003
Location: cullman, AL,
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
needle settings
Go to tower hobbies.com and look up the EK 4 and roll down to the specs. and they give you the factory settings there. It tells all three settings (high,mid,low). Maybe this will help.
#4
Junior Member
Join Date: Jan 2003
Location: New York
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
TT EK4 needle settings
I know this thread is like 5 days old, but I just wanted to step in here.
Do not refrence Towers or TTR's settings!! those settings are too lean and you will be up the creek without a paddle, and that is if you even get it running with those seettings.
First off, do you have a V1 or a V2 Pro .70?
The "broken-in" settings will vary from carb to carb, but this will give you a good basepoint.
These are the "broken-in" settings, reply if you need the "break-in" settings
First, get a OS #8 or McCoy #59 glow plug.
High - 3-3/4 out
Mid - Flush
Low - 1-3/4 turns out from fully closed
For more information on the settings, visit this post- EK4 settings page-
Do not refrence Towers or TTR's settings!! those settings are too lean and you will be up the creek without a paddle, and that is if you even get it running with those seettings.
First off, do you have a V1 or a V2 Pro .70?
The "broken-in" settings will vary from carb to carb, but this will give you a good basepoint.
These are the "broken-in" settings, reply if you need the "break-in" settings
First, get a OS #8 or McCoy #59 glow plug.
High - 3-3/4 out
Mid - Flush
Low - 1-3/4 turns out from fully closed
For more information on the settings, visit this post- EK4 settings page-