Has anyone ever seen or used this??
06-17-2003, 06:40 PM
#1
Senior Member
Thread Starter
Join Date: May 2003
Location: Monee, IL,
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone ever seen or used this??
I saw this a while back (like a year or so) and was wondering if anyone has bought one or knows anyone that has?? A 3 speed would be pretty cool IMO!
http://www.radrc.com/
P.S. I am looking at the 3 Speed tranny for a .21 Maxx!
http://www.radrc.com/
P.S. I am looking at the 3 Speed tranny for a .21 Maxx!
06-17-2003, 06:50 PM
#2
Senior Member
My Feedback: (4)
Join Date: Apr 2003
Location: Douglas,
WY
Posts: 842
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone ever seen or used this??
DAMN I didnt know they charged that much!!!!! Ive printed out some plans of how do do this myself about 2 years ago, but never did it, Ive seen a couple video's of a maxx with a 3-speed and 1/8th wheels and tires, it hauled ***** probably some where in the 40-50's maybe more, but I dont think its worth $130 for just the 2 speed conversion, you could probably make your for $40-50 installed. If yould like to go that route Ive got the plans and instructions on how to do it yourself!!
06-17-2003, 08:00 PM
#3
Senior Member
My Feedback: (3)
Join Date: Dec 2002
Location: San Benito, TX
Posts: 203
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone ever seen or used this??
WIll you give the plans free or charge?
I would like them. Althogh I think I know how but I am not sure.
Can you post them here?
I would like them. Althogh I think I know how but I am not sure.
Can you post them here?
06-17-2003, 08:16 PM
#4
Member
Join Date: Jan 2003
Location: Virginia Beach,
VA,
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone ever seen or used this??
Someone on here has a video of it. Definitely doesn't look like a tmaxx with as low as it was sitting, but I think it would be pretty cool.
06-23-2003, 05:18 PM
#6
Member
Join Date: Apr 2003
Location: Arlington, TX
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
3 speed refund
I bought the 3 speed. It didnt fit! After you slide the clutch bell on (has two gears) you wont have enough room left at the end of the shaft to put the washer and e-clip back on! I couldnt believe it myself but it didnt fit. This was the case for the Sirio .18 motor but if I remember correctly I immediately tried to install on my broken down 2.5 and it didnt fit either (shaft same length).
I sent mine back and had to pay a restocking fee
i only got 100 bucks back and a big headache in the whole ordeal.
I sent mine back and had to pay a restocking fee
i only got 100 bucks back and a big headache in the whole ordeal.
