1/8 Monster Truck Brushless conversion HELP
I have a Nitro 1/8 Thunder Tiger EK4 and Iwant to convert it to Brushless but I am unsure how to choose a motor. Can anyone explain the KV meaning and anything else that may help, I am looking for a motor that can make the truck move about 40 to 50 mph. I will also need a ESC I do not really want to spend a lot of $ but will consider more money to spend after a have a little more knowledge but anyone that can help me out. </p> |
RE: 1/8 Monster Truck Brushless conversion HELP
KV rating: This figure indicates the RPM of the motor per 1volt of electricity. For example, a 2000KV motor powered at 1v can turn up to 2000rpm. When powered at 7.4v, it can turn up to 14,800rpm.
For big vehicles like monsters and 1/8 scale the KV ratings are generally lower than those used in 1/10 and smaller vehicles. E-Revo andSavage Flux come from the factory with motors in the low 2000s KV rating, I believe about 2200. With 6S power these beasts and break speeds over 60MPH! Now, keep in mind that while installed in a vehicle these motors won't hit their maximum RPM in most cases. Here's an example of a system that you could potentially use in your rig: https://www.ssl-stormerhobbies.com/c...amp;pn=CCM6201 I don't think you're going to find anything for much less than $200 that will still power a large vehicle without burning up. Hobbyking may have something but I haven't checked. You'll want to use 4S LiPopowerorgreater (14.8v - 22.2v) and a higher MAh ratingto maximize run time. Be sure that you have a charger that can charge fast enough, otherwise you'll have to wait a while for the batteries to recharge. |
All times are GMT -8. The time now is 10:38 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.