Servo troubles
Hi
I have the ACME conquistador. One last question Have just re connected up the throttle to the servo link. When testing it with out running the engine the carb opening is wide open. I changed the throttle trim on the remote control but that hasn't helped. I did notice that their is two holes I could connect the servo link to. I have tried both holes but both had the same result. Any ideas? Cheers Tom |
RE: Servo troubles
At a guess it sounds like the throdle reverse switch has been activated.Usually found on the transmitter.
Or try centering the servo while its on, adjust all trims settings to centre, take the servo arm of the servo, while its all switched on still, make sure everything is centered, carefully put servo arm back on in centre position, carby should now be closed to idle. |
All times are GMT -8. The time now is 11:11 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.