RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   RC Monster Trucks (https://www.rcuniverse.com/forum/rc-monster-trucks-160/)
-   -   GEAR RATIO HELP (https://www.rcuniverse.com/forum/rc-monster-trucks-160/1500570-gear-ratio-help.html)

azrctruck 02-05-2004 06:53 PM

GEAR RATIO HELP
 
I wanted to play a bit with gear ratio on my MGT and savage. correct me if I am wrong to figure out your gear ration you take the spur gear and divided by the clutch bell for example on a stock mgt 52t/15t ratio 3.46. I am aware that this is not the final gear ratio to the wheels. So i am assuming that the lower the ratio the more top end speed the higher the ration the more low end. so if I went to a 52t/16t ratio 3.25 would give me more top end. so with that said what are valid spur gear / clutch bell combination for the MGT

cid 02-05-2004 11:47 PM

RE: GEAR RATIO HELP
 
page 15 in your MGT user guide will tell you every thing you need to know about gear ratio in the Mgt

azrctruck 02-09-2004 04:38 PM

RE: GEAR RATIO HELP
 
page 15 also shows a lot of spur gear and clutch bell combination that are not valid just try to install a 15/46 was not able to line up the engine

cid 02-09-2004 06:11 PM

RE: GEAR RATIO HELP
 
that may be true but you can get the same ratio with a 16/49 both work out to a 3.06


All times are GMT -8. The time now is 05:05 PM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.