RCU Forums - Stupid Question

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Monster Trucks (https://www.rcuniverse.com/forum/rc-monster-trucks-160/)

- - Stupid Question (https://www.rcuniverse.com/forum/rc-monster-trucks-160/870438-stupid-question.html)

POJack

06-17-2003 02:54 AM

Stupid Question

I'm trying to take the axle pin out of my CVD and it's stuck...I've tried using plyers and tapping it out...The thing won't budge. I've even tried adding a little oil and still not budging. Have any of you guys run into this probem? Any other ideas of what I could do?

BUGGIES_R_US

06-17-2003 03:08 AM

Stupid Question

Try a thick paperclip or something thats the same thickness? (drill bit).

Thats how I got it out
ram

Krusty

06-17-2003 04:25 AM

Stupid Question

Trying to pull the pin out with pliers (correct spelling) is never the correct way. Even if you are successful with that method, the piers will leave grip or "dig" marks in the pin. The proper method is to use a drift punch, the same diameter as the pin, to gently tap out the pin.

BUGGIES_R_US

06-17-2003 12:30 PM

Stupid Question

drift punch.. so thats what my method is called?! lol

Krusty! Havent seen you around recently!
-ram

nmtr13

06-17-2003 09:20 PM

Stupid Question

Did you take out the set screw?

POJack

06-17-2003 09:44 PM

Stupid Question

Quote:

Originally posted by nmtr13
Did you take out the set screw?

There is no set screw holding the axle pin in place, I've tried everything and it's like the thing is just epoxied in there or something...I don't know what else to do. I'm definately not going to spend another $50 for a new set of CVD's because I can't get a darn axle pin out...any other suggestions?

nmtr13

06-17-2003 10:05 PM

Stupid Question

You could try heating it up... I dont know if it would work but its the only thing i can think of. I CA'd my cvd pin in once by mistake, my lhs got it out. I think you can buy cvd's seperatly if you want, but just out of curiosity, why do you need to get the pin out?

POJack

06-17-2003 10:08 PM

Stupid Question

I need to get the pin out so I can take the axle out of the knuckle because I'm putting a different suspention on my truck.

Dlock

06-18-2003 12:15 AM

Stupid Question

I use a set of pliers, put one side on the axle, and the other side on one end of the pin. Then sqeeeeeeze!! Try to keep your fingers clear of the inside of the pliers, because sometimes they slip. Then you get a nice big owie........

POJack

06-18-2003 01:08 AM

Stupid Question

Quote:

Originally posted by Dlock
I use a set of pliers, put one side on the axle, and the other side on one end of the pin. Then sqeeeeeeze!! Try to keep your fingers clear of the inside of the pliers, because sometimes they slip. Then you get a nice big owie........

Thats what I tried initially. I'm not weak (or at least I like to think I'm not.. :D ) and the thing is STUCK...I don't know what else to do????

All times are GMT -8. The time now is 04:19 AM.