Has anyone ever seen or used this??
I saw this a while back (like a year or so) and was wondering if anyone has bought one or knows anyone that has?? A 3 speed would be pretty cool IMO!
http://www.radrc.com/ P.S. I am looking at the 3 Speed tranny for a .21 Maxx! |
Has anyone ever seen or used this??
DAMN I didnt know they charged that much!!!!! Ive printed out some plans of how do do this myself about 2 years ago, but never did it, Ive seen a couple video's of a maxx with a 3-speed and 1/8th wheels and tires, it hauled ***** probably some where in the 40-50's maybe more, but I dont think its worth $130 for just the 2 speed conversion, you could probably make your for $40-50 installed. If yould like to go that route Ive got the plans and instructions on how to do it yourself!!
|
Has anyone ever seen or used this??
WIll you give the plans free or charge?
I would like them. Althogh I think I know how but I am not sure. Can you post them here? |
Has anyone ever seen or used this??
Someone on here has a video of it. Definitely doesn't look like a tmaxx with as low as it was sitting, but I think it would be pretty cool.
|
Has anyone ever seen or used this??
No charge!! However I will not post them here, if yould like to see them Email me, Ill just send pix that way.
|
3 speed refund
I bought the 3 speed. It didnt fit! After you slide the clutch bell on (has two gears) you wont have enough room left at the end of the shaft to put the washer and e-clip back on! I couldnt believe it myself but it didnt fit. This was the case for the Sirio .18 motor but if I remember correctly I immediately tried to install on my broken down 2.5 and it didnt fit either (shaft same length).
I sent mine back and had to pay a restocking fee :( i only got 100 bucks back and a big headache in the whole ordeal. |
All times are GMT -8. The time now is 05:08 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.