almaidah

ok i want to put in a new engine in my bike but the engine i want uses a slide carb instead of the rotary one so do anyone have pics of their's with that setup so i can see how to put the servos in to remount them if needed and also i have a digital remote and wanted to know it i can have a extra servo for break and one for throttle. thanks

ehirobo ehirobo

To change to slide cab setup my friend had done it before. Sorry I don't have any photo but you can refer to the Nuova faor setup. Placing both servo at the upper chassis. For braking usually people use a single servo for both throttle and brakes. But if you have a 3ch radio system you can setup an extra servo for it. Or use a Y-connector to connect both servos to ch2.

almaidah

thank you.. so if i go with the Nuova faor setup what part will i need if you can help me with that also or do i just get Nuova faor servo mounts?

ehirobo ehirobo

Just cut the top chassis out of aluminum or carbon fiber sheet. I am not sure if the NF top chassis will fit on the TTn. I know the steering support are almost identical. The only different is the TT have have an extra hole of the pole to hold the driver's hand in place. I will try to measure it tonight and let you know.

almaidah

thanks for your help