xtm .18 xcellerator engine froze
05-12-2005, 08:24 PM
#1
Senior Member
Thread Starter
My Feedback: (2)
Join Date: Aug 2003
Location: lenox, MI
Posts: 1,388
Likes: 0
Received 0 Likes
on
0 Posts
xtm .18 xcellerator engine froze
well my xcellerator has not been run since janurary 05, so i went to turn the engine over yesterday and the piston froze, its stuck and now moving, how do i free it again, and do you think i hurt anything, thanks.
05-12-2005, 10:04 PM
#3
Senior Member
Thread Starter
My Feedback: (2)
Join Date: Aug 2003
Location: lenox, MI
Posts: 1,388
Likes: 0
Received 0 Likes
on
0 Posts
RE: xtm .18 xcellerator engine froze
well i have the engine off the car and i tried turning the fly wheel, but like i said it wont move, any suggestions.
05-13-2005, 01:37 PM
#4
Senior Member
My Feedback: (1)
Join Date: Aug 2004
Location: Syracuse,
UT
Posts: 2,216
Likes: 0
Received 0 Likes
on
0 Posts
RE: xtm .18 xcellerator engine froze
Toss it in the trash I had 2 of those poof both had connecting rod failures...I run a OS .18 CV-R in mine and modified the crappy XTM Clutch Bell setup that constantly would fall apart when bashing. My Xcell keeps right up with my Jato and gets it tough off the line since the xtm modified clutch has 0 slip when wot from stand still
