Brushless conversion engine
#2
Senior Member
Join Date: Dec 2006
Location: toms river, NJ
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
RE: Brushless conversion engine
make one man whats the point of a conversion if your just going to buy it all... You can get motor clamps and fit them onto the nitro block and just use the nitro mounts to get your mesh.. That would work..
#3
Senior Member
Join Date: Jun 2007
Location: st. paul,
MN
Posts: 339
Likes: 0
Received 0 Likes
on
0 Posts
RE: Brushless conversion engine
im in the middle of a brushless conversion myself and right now i figured the easiest way to make one is getting 1/16 inch raw alluminum and bending it in a L shape. http://www.rcuniverse.com/forum/m_64...tm.htm#6462995
J.D.T 's second homemade version looks to be an easy way to do it.
J.D.T 's second homemade version looks to be an easy way to do it.