ARIXTRA Build Thread by ISAAC NAJARY
#155
Thread Starter
Join Date: May 2003
Location: Ramat Hashrone, ISRAEL
Posts: 1,201
Likes: 0
Received 36 Likes
on
32 Posts
RE: ARIXTRA Build Thread by ISAAC NAJARY
ORIGINAL: Ryan Smith
Probably lubricating the wing tube so that any errant micro balloon/epoxy mixture will not glue it in place, or the wing to the tube.
Probably lubricating the wing tube so that any errant micro balloon/epoxy mixture will not glue it in place, or the wing to the tube.
Best regards,
Isaac Najary
#156
My Feedback: (90)
RE: ARIXTRA Build Thread by ISAAC NAJARY
Najary,
Just wonder if you plan to monokote the wings and if so, whether the monokote will stick with the material interfacing the fuze. Love to know your solution.
On my visa, I just added an extra thin balsa layer to interface the fuze. It was very hard to sand the balsa layer to perfectly fit the contour of the fuze.
Thanks
Just wonder if you plan to monokote the wings and if so, whether the monokote will stick with the material interfacing the fuze. Love to know your solution.
On my visa, I just added an extra thin balsa layer to interface the fuze. It was very hard to sand the balsa layer to perfectly fit the contour of the fuze.
Thanks
#157
Thread Starter
Join Date: May 2003
Location: Ramat Hashrone, ISRAEL
Posts: 1,201
Likes: 0
Received 36 Likes
on
32 Posts
RE: ARIXTRA Build Thread by ISAAC NAJARY
ORIGINAL: nonstoprc
Najary,
Just wonder if you plan to monokote the wings and if so, whether the monokote will stick with the material interfacing the fuze. Love to know your solution.
On my visa, I just added an extra thin balsa layer to interface the fuze. It was very hard to sand the balsa layer to perfectly fit the contour of the fuze.
Thanks
Najary,
Just wonder if you plan to monokote the wings and if so, whether the monokote will stick with the material interfacing the fuze. Love to know your solution.
On my visa, I just added an extra thin balsa layer to interface the fuze. It was very hard to sand the balsa layer to perfectly fit the contour of the fuze.
Thanks
Hi nonstoprc
See post 181.
http://www.rcuniverse.com/forum/m_93..._8/key_/tm.htm
Best regards,
Isaac Najary