Which servo(s)
#1
Thread Starter
Join Date: Mar 2003
Location: Melbourne, AUSTRALIA
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Which servo(s)
I have previously used JR then Futaba servos, most recently 9650 (2) on elevators, 9154 on ailerons and 9156 on rudder.....
I now have a Griffin to fit out. Request recommendations.......
Is the extra expense for BLS worth it? If so which ones?
I don't necessarily have a preference for JR or Futaba (or Hitec) but not Airtronics. I wish to use a standard size aileron servo, not a low profile (not 9154) because the hole in the wing is for a standard size (I can enlarge it if I must....)
The servo's will be commanded by a JR1221 receiver (so no Futaba SB) and powered by a regulated 5.9V.
Thanks in advance for your suggestions!
I now have a Griffin to fit out. Request recommendations.......
Is the extra expense for BLS worth it? If so which ones?
I don't necessarily have a preference for JR or Futaba (or Hitec) but not Airtronics. I wish to use a standard size aileron servo, not a low profile (not 9154) because the hole in the wing is for a standard size (I can enlarge it if I must....)
The servo's will be commanded by a JR1221 receiver (so no Futaba SB) and powered by a regulated 5.9V.
Thanks in advance for your suggestions!
#4
Senior Member
My Feedback: (1)
Join Date: Oct 2008
Location: Bridgewater,
VA
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
RE: Which servo(s)
AUS50518
Take a look at post under Electrid RC post #21 New Griffin . These were servo we use and they worked great. There all the hardware list htat's in plane.
Jr
Take a look at post under Electrid RC post #21 New Griffin . These were servo we use and they worked great. There all the hardware list htat's in plane.
Jr