Servo Question
#1
Thread Starter
My Feedback: (15)
Servo Question
I am using the nylon gear, JR 3421 SA Digital's on the Focus Sport, separate elevator servos, L & R, same set-up on one of the Intruder's. All fine. JR does not have these anymore, last time I looked, only the metal gear 3421's are avaliable. I have another Focus Sport on the way, looking to use the same set up, separate elevator servo's.
Question: I built the first F. Sport from Troy Newman's build thread. He said that the nylon gear 3421 SA's are recommended over the metal gear. I am using the Hyde mount with the YS110, whether this makes any difference/vibration, etc., metal vs nylon gear's. The new Focus will have the Hyde mount also. The MN48 nylon gear's are available, which are a drop in to the 3421.
I would appreciate comment's here, nylon vs. metal gear's in these servo's. As far as critical set-up, I would probably not now know the difference.
Thanks,
Vince
Hobe Sound, FL
#4
Senior Member
Join Date: Sep 2002
Location: Great Bend,
KS
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Question
To convert the 3421 Metal gears to the nylon gears, Use the 321 Gear set.
http://www.horizonhobby.com/Products...rodID=JRPSG321
Joe Dunnaway
http://www.horizonhobby.com/Products...rodID=JRPSG321
Joe Dunnaway
#5
RE: Servo Question
Sure thing, one thing to note, they discontinued the SA version and probably will the MG but those same servos are coming out on HV versions, 3421 already out with different numbers, and I saw the 9411 in the Japanese catalog or wing servo, don't remember.
Regards
Alejandro
Regards
Alejandro
#6
My Feedback: (50)
Join Date: Apr 2003
Location: Bolivia, NC
Posts: 558
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Question
If you need to buy servos anyway, get the Futaba 9650. It's about the same size as the JR 3421 and has a plastic gear train. I'm using them on a Voodoo Express and a 2M Integral. They are also cheaper than JR 3421 and they will work just fine with a JR or Spektrum 2.4 receiver .
#8
Thread Starter
My Feedback: (15)
RE: Servo Question
Thanks guy's. I will get a few of the 9650's. These forum's are great, get good "experienced" advice from many area's of the world, we all have a common interest. On another subject, I spoke with Rich Verano yesterday, YS Part's and Service. He said that the part's for the new YS115 are being manufactured now. Expect's the new 115 to be in the state's, at least by end of October. I am using the YS110S in my present Focus Sport, want to have some continuity with the new Focus..
Vince
Vince
#11
Junior Member
Join Date: Sep 2010
Location: naples, FL
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
RE: Servo Question
I am new here, I am building my first 450 need to know how much servo tork is rated or needed on the 450 so i can buy servos , i dont think i will be 3ding any time soon but a flip and roll are going to happen
thanks
pat450
thanks
pat450