Stick problem
#1
Member
Thread Starter
Join Date: Apr 2003
Location: MN
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Stick problem
On the Right stick for the elevater and aileron I have a slight problem. On the Axis that controls the aileron If I push it right it works fine. If I push it left pass center it doesnt affect anything go back right it works once it gets pass center. The TRIM is affected the SAME way.
Its a Futaba 6xA I bought a few years ago. Whats up!?!
Its a Futaba 6xA I bought a few years ago. Whats up!?!
#3
My Feedback: (147)
Join Date: Apr 2002
Location: Atlanta ,
GA
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
Stick problem
I do not think it is something in the programing. I have a JR four channel AM analog transmitter that has the same problem. All four channels only work in one direction. Trim tabs work the same way. Unfortunately it would not be economical to send that unit in for repair. It may be for yours.
#4
Senior Member
Join Date: Feb 2002
Location: Lynnfield, MA
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Stick problem
It could be programmed to have that effect. Check the ATV menu for channel 1, there are programmable percentages of travel for both left and right movements. If you move the stick left and see 0% or close to 0% on the menu, that's the problem.
I have heard that you can download the manual for this radio, do a search and see what you can find.
I have heard that you can download the manual for this radio, do a search and see what you can find.