Volz Wing Maxx HP noise question.
#1
Thread Starter
Volz Wing Maxx HP noise question.
I have just setup twin volz wing maxx HP's on the elevators of a DF sabre. The servos are installed in the stab itself. When the servo is operated, they are noisy as heck. Are Volz known to be noisy? Or do I have a noisy pair? They are full metal gears I believe. The noise is not due to any binding, as they are noisy even when sitting on the table without any load. Noise here means motion noise..not servo buzzing.
#2
Junior Member
My Feedback: (1)
Join Date: Jan 2003
Location: Long Beach, CA
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Volz Wing Maxx HP noise question.
Metal gears by nature WILL be noisy. I would think some lubrication would quiet them but then if they are new, I would leave them alone. The Germans are great engineers who pay very close attention to detail. I'm sure they're fine the way they are.
Just my 2 cents
Just my 2 cents