Pitch Servo problem
08-06-2003, 10:12 PM
#1
Junior Member
Thread Starter
Join Date: Aug 2003
Location: Leeds, UNITED KINGDOM
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Pitch Servo problem
I have just finished building my Raptor installed all radio gear servo's etc. I then programed the pitch curve & throttle curve values from the raptor instructions. everything seems to work fine except the pitch servo. It is in the neutral position which lines up with the hover mark on the side frame. When i push the throttle stick up or down to line the up with the other markers the servo is not giving enough travel to accomplish this. i have adjusted the ATV's to the maximum of 140% still not enough travel to line up with the 11 degree & -2 degree marks on the raptor. Anyone any suggestions ? adjusting the pushrod just messes everything up !
08-07-2003, 12:57 AM
#2
Banned
Join Date: Oct 2002
Location: Austin, TX
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
Pitch Servo problem
You might have better luck getting a responce if you post this in the heli forum. Try the link below.
http://www.rcuniverse.com/forumdispl...s=&forumid=180
http://www.rcuniverse.com/forumdispl...s=&forumid=180
08-11-2003, 08:06 AM
#3
Junior Member
Join Date: Aug 2003
Location: Secunda, SOUTH AFRICA
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Pitch Servo problem
shorten the linkage between the servo and the pitch "arm". The distance, center to center of the linkage arm between the eyelets should be about 57mm (according to the manual).
