Going Balistic

I have an XP783 that has about 5 planes programmed in but I now need to add a new plane which has split elevators.

What a nightmare, it has taken me almost as much time to figure out the programming for the elevators as it did to build the plane.

Despite reading the manual numerous times I cannot seem to figure this one out.

My original mix was on "mix a", everything seemed ok until I attempted to adjust the dual rates for the elevator channel. Before adjusting the DR both elevator halfs moved correctly.

Once I adjusted DR, channel 6 (other side of split elevator) would not move at all.

Re-read the manual and noticed that mix "E & F" permitted trim, etc to be mixed and then tried the whole scenario on that mix and still no luck.

Any ideas JR programming gurus?

Thanks in advance,

GB

ec121k

Try to copy this over on the JR specific site and run it by Danny. He should be able to get you going.

Tony

Going Balistic

Thanks for the info.

Where can I find the JR specific site?

JR's web site?

Thanks,

GB

ec121k

The address is below. Also, look under this catagory and you'll see "Radio Manufacturer's Sub-forums". JR has one along with the others.

Good luck,
Tony



http://www.rcuniverse.com/forumdispl...forumid=174&s=