JR programming issue
#1
Thread Starter
Join Date: Nov 2002
Location: Barrie, ON, CANADA
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
JR programming issue
I have an XP783 that has about 5 planes programmed in but I now need to add a new plane which has split elevators.
What a nightmare, it has taken me almost as much time to figure out the programming for the elevators as it did to build the plane.
Despite reading the manual numerous times I cannot seem to figure this one out.
My original mix was on "mix a", everything seemed ok until I attempted to adjust the dual rates for the elevator channel. Before adjusting the DR both elevator halfs moved correctly.
Once I adjusted DR, channel 6 (other side of split elevator) would not move at all.
Re-read the manual and noticed that mix "E & F" permitted trim, etc to be mixed and then tried the whole scenario on that mix and still no luck.
Any ideas JR programming gurus?
Thanks in advance,
GB
What a nightmare, it has taken me almost as much time to figure out the programming for the elevators as it did to build the plane.
Despite reading the manual numerous times I cannot seem to figure this one out.
My original mix was on "mix a", everything seemed ok until I attempted to adjust the dual rates for the elevator channel. Before adjusting the DR both elevator halfs moved correctly.
Once I adjusted DR, channel 6 (other side of split elevator) would not move at all.
Re-read the manual and noticed that mix "E & F" permitted trim, etc to be mixed and then tried the whole scenario on that mix and still no luck.
Any ideas JR programming gurus?
Thanks in advance,
GB
#4
Junior Member
Join Date: Mar 2002
Location: Conestoga, PA
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
JR programming issue
The address is below. Also, look under this catagory and you'll see "Radio Manufacturer's Sub-forums". JR has one along with the others.
Good luck,
Tony
http://www.rcuniverse.com/forumdispl...forumid=174&s=
Good luck,
Tony
http://www.rcuniverse.com/forumdispl...forumid=174&s=