Question
#1
Junior Member
Thread Starter
Join Date: Dec 2010
Location: State college,
PA
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Question
In the truck I'm building has 6 car batteries in parallel it needs ten channels. Would it work if I hooked a motor controller to each motor and linear actuator and the receiver channel to each controller. Of course having the power and grounds to the controller. Would that work
#2
Senior Member
My Feedback: (20)
Join Date: Nov 2002
Location: Harlem,
GA
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
RE: Question
why do you need 10 chanels?how many motors are there?motor controllers?how many linear actuators are there?used for what?
what radio system do you have?what receiver/channels?
Exactly what are you asking?explain what you are doing and what components you have
and what they are being used for.
a little more info will go a long way.
what radio system do you have?what receiver/channels?
Exactly what are you asking?explain what you are doing and what components you have
and what they are being used for.
a little more info will go a long way.
#3
Junior Member
Thread Starter
Join Date: Dec 2010
Location: State college,
PA
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
RE: Question
Well I'm building a 13 foot heavy duty wrecker. Motor for drive and steering, two linear actuators for boom up n down, one for stinger in n out, one for stinger up n down, one each for left n right outrigger up n down, and also two more for winches. I really don't know what kind of trans n reciever I should get