Standard JRDS821 servos on 6v?
#1
Senior Member
Thread Starter
Join Date: Nov 2009
Location: Marion,
IA
Posts: 1,151
Likes: 0
Received 0 Likes
on
0 Posts
Standard JRDS821 servos on 6v?
Hello everyone. Just had a quick radio question as I'm switching all my 4.8 receiver batteries to 6v. The servo rating is for 6v, but when fully charged, the battery is around 6.2 to 6.5 volts give or take, am I going to cook the servo when its a little above like this? I'll be running 4 of these servos total in the airplane.
Thanks
Jason
Thanks
Jason
#3
Senior Member
Thread Starter
Join Date: Nov 2009
Location: Marion,
IA
Posts: 1,151
Likes: 0
Received 0 Likes
on
0 Posts
RE: Standard JRDS821 servos on 6v?
ORIGINAL: Pilot232
821's are all I use. I run them on A123's (fully charged they can reach 7.2 volts, the same as a five cell NIMH pack, no regulatr required). Enjoy.
821's are all I use. I run them on A123's (fully charged they can reach 7.2 volts, the same as a five cell NIMH pack, no regulatr required). Enjoy.
Jason
#6
Senior Member
Thread Starter
Join Date: Nov 2009
Location: Marion,
IA
Posts: 1,151
Likes: 0
Received 0 Likes
on
0 Posts
RE: Standard JRDS821 servos on 6v?
ORIGINAL: BarracudaHockey
What kind of plane? Those servos have some limitations
What kind of plane? Those servos have some limitations
Jason