Help with 8fgs and 6014
#1
Thread Starter
My Feedback: (6)
Join Date: Jan 2005
Location: Central,
FL
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
Help with 8fgs and 6014
Hey all,
I am finishing up a p-47. I ran all servos to their own channels so not to have to use y's. My elevator servos are on 2 and 10 so channel 10 is assigned to j2 (ele). However I went to set up my choke servo and put it on channel 11.. When I assigned a switch to it all channels 10,11 and 12 changed to that switch therefore channel 10 ele was now assigned to the choke switch. Is there anyway to not have all three channels switch to the same switch?
Thx for any help
I am finishing up a p-47. I ran all servos to their own channels so not to have to use y's. My elevator servos are on 2 and 10 so channel 10 is assigned to j2 (ele). However I went to set up my choke servo and put it on channel 11.. When I assigned a switch to it all channels 10,11 and 12 changed to that switch therefore channel 10 ele was now assigned to the choke switch. Is there anyway to not have all three channels switch to the same switch?
Thx for any help