Did this hurt my radio gear?
#1
Senior Member
Thread Starter
My Feedback: (10)
Join Date: Feb 2003
Location: Jonesboro,
GA
Posts: 818
Likes: 0
Received 0 Likes
on
0 Posts
Did this hurt my radio gear?
Guys,
I recently turned my Tx on, (Futaba 9C), while it was on PCM mode, but my planes Rx is on PPM. My servos started glitching like crazy, before I realized what I had done. I quickly turned my Tx off, and switched back over to PPM.
This happened, because I am setting up another plane on PCM, but I also fly a plane on PPM. Both receivers are channel 21, but one is PCM and one is PPM.
I did a range check, and everything seemed ok, but I was worried I may have damaged something. Thanks for any advice.
P.S. Servos were Hitec 56 and 5945mgs. THanks.
I recently turned my Tx on, (Futaba 9C), while it was on PCM mode, but my planes Rx is on PPM. My servos started glitching like crazy, before I realized what I had done. I quickly turned my Tx off, and switched back over to PPM.
This happened, because I am setting up another plane on PCM, but I also fly a plane on PPM. Both receivers are channel 21, but one is PCM and one is PPM.
I did a range check, and everything seemed ok, but I was worried I may have damaged something. Thanks for any advice.
P.S. Servos were Hitec 56 and 5945mgs. THanks.
#3
Senior Member
My Feedback: (4)
Join Date: Feb 2002
Location: CA
Posts: 1,166
Likes: 0
Received 0 Likes
on
0 Posts
RE: Did this hurt my radio gear?
ORIGINAL: Paul Cataldo
Guys,
I recently turned my Tx on, (Futaba 9C), while it was on PCM mode, but my planes Rx is on PPM. My servos started glitching like crazy, before I realized what I had done. I quickly turned my Tx off, and switched back over to PPM.
This happened, because I am setting up another plane on PCM, but I also fly a plane on PPM. Both receivers are channel 21, but one is PCM and one is PPM.
I did a range check, and everything seemed ok, but I was worried I may have damaged something. Thanks for any advice.
P.S. Servos were Hitec 56 and 5945mgs. THanks.
Guys,
I recently turned my Tx on, (Futaba 9C), while it was on PCM mode, but my planes Rx is on PPM. My servos started glitching like crazy, before I realized what I had done. I quickly turned my Tx off, and switched back over to PPM.
This happened, because I am setting up another plane on PCM, but I also fly a plane on PPM. Both receivers are channel 21, but one is PCM and one is PPM.
I did a range check, and everything seemed ok, but I was worried I may have damaged something. Thanks for any advice.
P.S. Servos were Hitec 56 and 5945mgs. THanks.