Servo end point
#1
Junior Member
Thread Starter
Join Date: Jan 2014
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Servo end point
Hi Guys.. I have fitted my gimbal to my Naza F550 and have connected the gimbal so that I can manually tilt the gimbal down, the problem I have is that the gimbal only tilts 35 degrees and not 45 degrees. I have adjusted the end points on my TX "Futaba T8FG". to the maximum.
Is there any way I can adjust this so I can tilts this the full 45 degrees
Thanks
Is there any way I can adjust this so I can tilts this the full 45 degrees
Thanks