Antena of Corona RP8D1 8ch 40MHz Dual Conversion Receiver
10-13-2017, 09:53 AM
#1
Junior Member
Thread Starter
Join Date: Apr 2006
Location: ATHENS, GREECE
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Antena of Corona RP8D1 8ch 40MHz Dual Conversion Receiver
Dear friends ,
I have lost a 10 cm piece of the Antena of Corona RP8D1 8ch 40MHz Dual Conversion Receiver .
What can i do to make the receiver operate properly again ?
Thank you in advance.
I have lost a 10 cm piece of the Antena of Corona RP8D1 8ch 40MHz Dual Conversion Receiver .
What can i do to make the receiver operate properly again ?
Thank you in advance.
10-13-2017, 09:49 PM
#2
My Feedback: (2)
Join Date: Feb 2003
Location: Palm Bay, FL
Posts: 1,046
Likes: 0
Received 0 Likes
on
0 Posts
10cm shouldn't have much effect.
You can solder on another 10cm piece of wire onto the end of the remaining antenna and it will work. Heat shrink the joint. Check range before flying.
You can solder on another 10cm piece of wire onto the end of the remaining antenna and it will work. Heat shrink the joint. Check range before flying.
