Jeti REX10 Assist new firmware problem
#1
Thread Starter
Join Date: Sep 2018
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Jeti REX10 Assist new firmware problem
Hi all!
I'm having a problem with my REX 10 assist receiver just after the update to firmware 1.12 from 1.09: switching on the receiver I have a message on transmitter saying "Hold Leveled" and the receiver doesn't run.
Naturally the model is steady still on a table, no any vibration or movement.
With firmware 1.10 problem is the same.
Back to older firmware 1.09 everything works fine.
Anyone experienced any similar problem?
Thank you very much for your help
I'm having a problem with my REX 10 assist receiver just after the update to firmware 1.12 from 1.09: switching on the receiver I have a message on transmitter saying "Hold Leveled" and the receiver doesn't run.
Naturally the model is steady still on a table, no any vibration or movement.
With firmware 1.10 problem is the same.
Back to older firmware 1.09 everything works fine.
Anyone experienced any similar problem?
Thank you very much for your help
#2
My Feedback: (52)
Join Date: Jun 2011
Location: Molalla,
OR
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Hi all!
I'm having a problem with my REX 10 assist receiver just after the update to firmware 1.12 from 1.09: switching on the receiver I have a message on transmitter saying "Hold Leveled" and the receiver doesn't run.
Naturally the model is steady still on a table, no any vibration or movement.
With firmware 1.10 problem is the same.
Back to older firmware 1.09 everything works fine.
Anyone experienced any similar problem?
Thank you very much for your help
I'm having a problem with my REX 10 assist receiver just after the update to firmware 1.12 from 1.09: switching on the receiver I have a message on transmitter saying "Hold Leveled" and the receiver doesn't run.
Naturally the model is steady still on a table, no any vibration or movement.
With firmware 1.10 problem is the same.
Back to older firmware 1.09 everything works fine.
Anyone experienced any similar problem?
Thank you very much for your help