Sanwa RD6000Super Setup
10-02-2003, 02:28 AM
#1
Junior Member
Thread Starter
Join Date: Jun 2003
Location: UK
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Sanwa RD6000Super Setup
Can anybody help PLEASE....
I have been trying to setup my RD6000Super for an Eolo but am stuck with one setting. When you give it full left aileron the motor slows down but give it full right aileron and the motor speeds up.
Everything else seems to work fine but I must have some kind of mix switched on, I have looked through the Sanwa manual but it does not mention Throttle mixing.
The TX is also now doing the same when trying to control my Picolo now -It didn't before???
I have been trying to setup my RD6000Super for an Eolo but am stuck with one setting. When you give it full left aileron the motor slows down but give it full right aileron and the motor speeds up.
Everything else seems to work fine but I must have some kind of mix switched on, I have looked through the Sanwa manual but it does not mention Throttle mixing.
The TX is also now doing the same when trying to control my Picolo now -It didn't before???
10-02-2003, 02:18 PM
#2
RE: Sanwa RD6000Super Setup
Look under thr ETC menu for the mixing functions. It sounds like you have mixing between the throttle and ali.
You will see MA and SLV and a % value you have set for mixing. Just zero all out and it should be fine.
Dru.
You will see MA and SLV and a % value you have set for mixing. Just zero all out and it should be fine.
Dru.
10-02-2003, 06:34 PM
#3
Junior Member
Join Date: Jul 2003
Location: Kansas City
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
RE: Sanwa RD6000Super Setup
Blbdbuzzard
Could you tell me more on your foam 757 jet. I would like to build one. Email me at [email protected]
Joel Cox
Please help me
Could you tell me more on your foam 757 jet. I would like to build one. Email me at [email protected]
Joel Cox
Please help me
