Servo Case Demensions ----Are They The Same??
#1
Senior Member
Thread Starter
My Feedback: (11)
Join Date: Jul 2003
Location: Stoughton,
WI
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
Servo Case Demensions ----Are They The Same??
I was wondering are most "Standard" servos the same size/demensions between manufactures? Meaning if you took a Futaba, Airtronics, Hitec standard servo and lined them up would they all pretty much be the same in case size. Any input would be appreciated. Thanks.
#2
My Feedback: (18)
RE: Servo Case Demensions ----Are They The Same??
My experience using Hitec, Futaba, JR, Tower, Cirrus, etc is that they are all pretty much the same size. They are not exactly the same dimensions, but very close and swapping one brand out for another is not usually a problem.
They do differ in output shaft diameter and spline count so the arms are not compatible. They also differ in rotation direction. Not all servos turn the same direction when the channel is in "normal" mode...
They do differ in output shaft diameter and spline count so the arms are not compatible. They also differ in rotation direction. Not all servos turn the same direction when the channel is in "normal" mode...