Convert Servo Ends from Hitec/JR to Futaba
#1
Junior Member
Thread Starter
Join Date: Oct 2003
Location: Sioux Falls, SD,
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Convert Servo Ends from Hitec/JR to Futaba
Hi,
I need some info on how to change the ends on a hitec 81MG servo. I plan on using a new Futaba J End so I am needing to know what wires go where.
Currently in order with the window facing up, I have Yellow, Red, Black.
I assume with the Futaba end with the window facing up I would wire it to be Yellow, Red, Black?
The only reason I am double checking this is I read a couple post's about switching the red and the black wire on the end to make it compatable when going from futaba to JR or hitec.
Thanks guys,
John
I need some info on how to change the ends on a hitec 81MG servo. I plan on using a new Futaba J End so I am needing to know what wires go where.
Currently in order with the window facing up, I have Yellow, Red, Black.
I assume with the Futaba end with the window facing up I would wire it to be Yellow, Red, Black?
The only reason I am double checking this is I read a couple post's about switching the red and the black wire on the end to make it compatable when going from futaba to JR or hitec.
Thanks guys,
John
#2
Senior Member
Join Date: Oct 2002
Location: Ontario, ON, CANADA
Posts: 1,309
Likes: 0
Received 0 Likes
on
0 Posts
RE: Convert Servo Ends from Hitec/JR to Futaba
Match the red and black, those are power.
I have Hitec servo with a JR connector and use it with Futaba equipment. No problem. Just ensure the polarity is correct when you plug it in - i.e. match red and black.
I have Hitec servo with a JR connector and use it with Futaba equipment. No problem. Just ensure the polarity is correct when you plug it in - i.e. match red and black.