FUTABA SERVO QUESTION
#1
Thread Starter
My Feedback: (55)
FUTABA SERVO QUESTION
I just acquired a used pattern ship that had two Futaba S9202 servos still
in it. I have always used JR equipment so my question is what to do to make
Futaba servos work with a JR receiver? This has probably been asked numerous
times but I guess I wasn't paying attention.
tommy s
in it. I have always used JR equipment so my question is what to do to make
Futaba servos work with a JR receiver? This has probably been asked numerous
times but I guess I wasn't paying attention.
tommy s
#2
Senior Member
My Feedback: (12)
Join Date: Dec 2001
Location: Pampa, TX
Posts: 5,133
Likes: 0
Received 0 Likes
on
0 Posts
RE: FUTABA SERVO QUESTION
Just carefully shave the little aignment tab off the Futaba connector and make sure to plug it in so that the White wire on the Futaba is where the Orange wire of the JR goes..the label side of the RX.