Futaba 9Zaps WCII Help!!
03-29-2004, 04:08 AM
#1
Junior Member
Thread Starter
My Feedback: (17)
Join Date: Mar 2004
Location: Phoenix,
AZ
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 9Zaps WCII Help!!
I am the proud owner of a new 9Zaps WC II. One thing I noticed is the alarm LED is lit all the time and I cannot get it to turn off. The manual gives me the impression that it should not be. Any one know? thx [&o]
Aaron
Aaron
03-29-2004, 11:31 AM
#3
Junior Member
Thread Starter
My Feedback: (17)
Join Date: Mar 2004
Location: Phoenix,
AZ
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 9Zaps WCII Help!!
yeah, I tried all that but it stays on all the time. I even checked the conditions the maual says will keep the light on with no luck. I hate to have to send it in already [:@]
03-29-2004, 04:30 PM
#5
Senior Member
My Feedback: (17)
Join Date: Jul 2002
Location: Enterprise,
AL
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 9Zaps WCII Help!!
My 9ZAP does the same thing, you should be able to get it turn off by selecting a model that doesn't have anything programmed. I believe that your 9Z is probably working as it should.
03-29-2004, 04:37 PM
#6
My Feedback: (1)
Join Date: Apr 2003
Location: Left Coast ,
CA
Posts: 4,890
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 9Zaps WCII Help!!
IF all else fails, reset all the parameters on a single model (or all models). That will clear all conditions, mixes, etc.
sorry, I thought I read flashing oops.
sorry, I thought I read flashing oops.
03-29-2004, 10:38 PM
#8
My Feedback: (1)
Join Date: Apr 2003
Location: Left Coast ,
CA
Posts: 4,890
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 9Zaps WCII Help!!
By the way, the alarm will not light if you start the tx in NON tx mode. Also the power light will occationally blink, something to do with coping data.
