DSLDUG

My Feedback: (1)

I know this question has been asked before but I cant figure out how to program to get the crow function to work.I went to the Futaba FAQ page and printed their directions on how to program but I still cant get it.Im not sure what Im doing wrong.I also want to know how to assign it to the switch of my choice.PLEASE HELP.


I was able to get the ailerons to work properly.I was also able to get the flaps to work properly.The flaps are activated by the left slider.I actually had set it up for switch A.When Ihit the switch the flaps would move properly but the ailerons wouldnt move up like their supposed to,they didnt do anything.

David_Moen

I'm about to embark on the same project, except with an Ultra Stick Lite. I'm wondering if it would be easier to start out with a complex wing glider template.

3DFanatic

My Feedback: (5)

Set up the outboard surfaces as flaperons (ch1 and 6) and the inboard flaps on say ch7. Set you ch6 to whatever switch and then mix ch7 to it.

Henry_90lx

I posted a complete programing set up for the US with flaps in the futab suport forum.

Here is the link. Let me know if you have any questions or need any thing cleared up.

http://www.rcuniverse.com/forum/9CAP...1399338/tm.htm

Henry