Blair 61

This might be a little different but I have a GWS 4 channel receiver and have built a small airplane that I need to just have ailerons and elevator. The question is can I or how can I change the Rudder channel 4 to act as another channel for the ailerons. I have a servo for each aileron. Which would mean I need 1&4 for ailerons 2 for elevator 3 for throttle. If it is possible please let me know. I have been fiddling with this for about 3 days now. If not I will just have to get another receiver.

Thanks

rhd-RCU

My Feedback: (36)

You can only use channel five or six, Whichn you don't have. Or the simple way would be a y harness.

Icebird

You will have to set up a PMix using channel 1 as the master and channel 4 as the slave. You will also need to turn on Link and trim whatever they are called on the 9C, but it is certainly within the realm of possibilities.

HTH
Jim

rhd-RCU

My Feedback: (36)

Will the trim work both channels?

Icebird

If you set it up right, yes the trim will work both channels.

Jim