locking servo position (?)
#1
Thread Starter
My Feedback: (4)
Join Date: Jan 2002
Location: Prague, CZECH REPUBLIC
Posts: 4,144
Likes: 0
Received 0 Likes
on
0 Posts
locking servo position (?)
hi, i need to lock the servo arm in the neutral position- without the servo being connected
my tx is in repair, thus i will be using a backup 4 ch tx. my problem is keeping the two flap servos locked in the neutral position (without having a channel available for them)
can it be done? is there another solution to my problem?
remember i will get my primary 6ch tx back in couple of weeks, so i don't want to make any radical changes to the seup (taking the servos out, physically linking the flaps to the ailerons ect...)
all ideas are welcome,
[8D]
Vasek
my tx is in repair, thus i will be using a backup 4 ch tx. my problem is keeping the two flap servos locked in the neutral position (without having a channel available for them)
can it be done? is there another solution to my problem?
remember i will get my primary 6ch tx back in couple of weeks, so i don't want to make any radical changes to the seup (taking the servos out, physically linking the flaps to the ailerons ect...)
all ideas are welcome,
[8D]
Vasek