futaba 7c
#1
Thread Starter
My Feedback: (2)
Join Date: Jul 2003
Location: wilmington, MA
Posts: 829
Likes: 0
Received 0 Likes
on
0 Posts
futaba 7c
have new futaba 7c. do not like small surface movement when using digital trims to trim full up to full down. sliders on 6ax seemed to have much more control surface movement. any way to increase movement (not the rate of movement)?
#2
My Feedback: (2)
RE: futaba 7c
The radio will drive the servos to 100% of their throw. If you seem to have a limit, you have a setting wrong somewhere.
I have a 9C, but I believe the 7C works the same way on the trims. You can set the value of each click on the digital trims.
As far as servo movement, I have my left side slider set as the flaps and they go through a full 90 degrees.
Check your settings and, if possible be more specific as to what you are trying to move and we might be able to help you.
I have a 9C, but I believe the 7C works the same way on the trims. You can set the value of each click on the digital trims.
As far as servo movement, I have my left side slider set as the flaps and they go through a full 90 degrees.
Check your settings and, if possible be more specific as to what you are trying to move and we might be able to help you.